Timer 1 to 12 hours · Power 120 V / 60 Hz · Tracked shipping (5-10 days) · 30-day returns

ANGAHE — Warm Bathroom, No Cord On The Floor

Wall-Mounted

Warm Bathroom, No Cord On The Floor

A 1500W heater that mounts high on the wall, off the floor, with a remote so you never reach for a switch with wet hands

13 x 10.24 x 3.94 in
4.41 lb
Indoors

$89.99

Color

1 unit Try it $89.99

Best deal 2 units Best value $152.98 $76.49/unitSave 15%

Warm Up My Bathroom — $152.98 →

Tracked shipping in 5-10 days · 30 days to send it back

Secure checkout · SSL encrypted

Tracked shipping in 5-10 days
30-day returns
Secure SSL-encrypted checkout

How to use it

Mount it to the wall at least 71 inches off the floor, using two screws 6 inches apart (screws included).
Plug it into a dedicated 15A outlet, keeping it at least 20 inches from side walls.
Use the remote (up to 16 ft away) to pick 750W or 1500W and set a timer from 1 to 12 hours.

Tracked shipping
30-day returns
100% secure checkout
Email support
Tracked shipping
30-day returns
100% secure checkout
Email support

1500 WTwo heat settings: 750 W or 1500 W
1–12 hTimer, then it switches itself off
16 ftRemote range (13–16 ft), from the doorway
71 inMinimum mounting height, well off the floor

Why you'll love it

Built for the one room with water everywhere
Mounts at least 71 inches up and out of reach of the tub or shower, so it's doing its job above the splash zone instead of sitting on wet tile.
Two heat settings, one outlet
750W for taking the chill off, 1500W when you need it fast, both running on a dedicated 15A outlet so it's not fighting your hair dryer for power.
Set it and walk away
Pick a timer from 1 to 12 hours and it shuts itself off. No remembering to go back and check it before bed.
Shuts down if it overheats
If the inside gets too hot, it cuts its own power. The control panel also locks with a 3-second hold so a bump or curious hand can't change the settings.
Two screws, 6 inches apart
It screws to the wall at least 71 inches up, with two holes 6 inches apart. The screws come in the box.

Get to know it

You get out of the shower and the floor heater you've been using is sitting right there in the splash zone, cord and all. It works, but you're always a little careful around it. This wall heater solves that by living on the wall instead — above the water, out of the way, exactly where a bathroom heater should be.

It screws to the wall with two holes 6 inches apart, high above the splash zone. Once it's up, you run it from the remote: pick 750W to take the morning chill off or 1500W when you want it fast, and set a timer from 1 to 12 hours so it shuts off on its own.

It's made for one room and one use: wall-mounted, indoors, kept well clear of the tub or shower. The panel locks with a 3-second hold so it won't get bumped into a different setting, and it cuts its own power if it runs too hot.

See it in action

How it works

01Mount it to the wall at least 71 inches off the floor, using two screws 6 inches apart (screws included).
02Plug it into a dedicated 15A outlet, keeping it at least 20 inches from side walls.
03Use the remote (up to 16 ft away) to pick 750W or 1500W and set a timer from 1 to 12 hours.

Warm before you step in

Switch it on from the doorway with the remote and the bathroom warms up while the water runs.

Frost outside, warm inside

Pick 750 W or 1500 W and a timer from 1 to 12 hours. It switches itself off.

Off the floor, out of the way

Two screws hold it high on the wall, clear of the floor and the tub.

Wall-Mounted vs. Standard Floor Heater

	ANGAHE	Typical alternative
Where it sits	Mounted on the wall, at least 71 in up and clear of the tub or shower	Sits on the floor, often close to wet feet and splash zones
Install	Two wall screws 6 in apart, screws included	No mounting — just plugged in and placed on the floor
Control	Remote control from up to 16 ft away, with a lockable panel	Usually manual dial or buttons on the unit itself

Real specs, no fine print

Specifications

Heat settings	750 W low / 1500 W high
Safety listing	ETL Listed to UL 1278 and CSA C22.2 No. 46 (control no. 5033952)
Overheat protection	Cuts the power by itself if the inside gets too hot
Child lock	Hold for 3 seconds to lock the control panel
Timer	1 to 12 hours, then it switches itself off
Mounting	Screws to the wall with two holes 6 in apart (screws included)
Where it goes	At least 71 in off the floor and 20 in from side walls; in a bathroom, out of reach of the tub or shower
Power	120 V / 60 Hz, on a 15 A outlet of its own
Remote control	Included, with CR2025 battery and a child-resistant battery door (UL 4200A)
Remote range	13-16 ft (4-5 m)
Size	13 x 10.24 x 3.94 in
Weight	4.41 lb
Use	Indoors, wall-mounted only: not for the floor

What's in the box

Wall heater unit
Remote control with CR2025 battery
Mounting screws

Frequently asked questions

Will this actually fit in my bathroom?

It's 13 x 10.24 x 3.94 inches and mounts on the wall, not the floor. As long as you have wall space at least 71 inches up and 20 inches from side walls, away from the tub or shower, it'll fit.

How does it mount?

Two screws in the wall, 6 inches apart, at least 71 inches off the floor and 20 inches from side walls. The screws are included.

Is it rated for a wet room like a bathroom?

It's ETL Listed to UL 1278 and CSA C22.2 No. 46, the safety standards for this type of wall heater, and it's meant to be installed out of reach of the tub or shower, not inside the splash zone.

Can I put it on the floor instead?

No, it's built for wall mounting only — it's not designed or rated to sit on the floor.

What if I forget to turn it off?

Set the timer for anywhere from 1 to 12 hours and it switches itself off automatically. It also has its own overheat shutoff if the inside gets too hot.

Heat where you actually stand, not the whole room

30-day return window
Tracked shipping, arrives in 5-10 days
Secure checkout

Get mine →

ANGAHE

2 units · $152.98

Shop now →